Welcome to Shenzhen Grande Electronic Co., Ltd.!

Shenzhen Grande Electronic Linkedin Page

E-mail us for a Quote:
sales88@greattong.com

Call us now:
+86-755-83261869

How do I design a rigid-flex PCB?

2019-07-02

Frankly speaking, the design of rigid-flex board is much more complicated than other traditional PCB design so that there are plenty of aspects that we should pay attention to, such as rigid-flex transitional areas, related routing, vias design, etc.

Does a resistor reduce current and voltage?

2019-07-01

Absolutely! In fact, resistor is like a current limiter, which limits the amount of current flowing through a device.

Where can I have someone check my schematic and PCB?

2019-07-01

In the process of PCB design, a correct schematic is an essential precondition for PCB fabrication so that the schematic must be guaranteed before generating rhe netlist into the PCB.

Can other materials replace gold in electronics?

2019-06-28

Yup. In fact, there are a kind of new copper-based material (based on copper nanoparticles) that can be used to replace those expensive precious metals of printed electronics, such as silver, gold, etc.

If you are soldering something, how long does it take for the solder to cool?

2019-06-28

Well, it actually depends upon the components that we are soldering; In general, it usually takes 10 seconds for those SMD resistors and capacitors to cool. However, for ICs, which mainly replies on the its volume. For example, it takes about 20 seconds f

How can cold solder joints be prevented?

2019-06-27

As we all know, cold solder joint is one of the common line faults of PCBA, so why does it happen?

Which sites provide PCB packaging?

2019-06-27

1. Official website of the components brand: The components specification data including packaging information will be provided on it; 2. Third-party platforms: Specifications and packaging information of components will also be provided on such platfo

Which factors in PCB design that affect PCB Assembly?

2019-06-27

PCB Assembly is conducted according to the production data of PCB design. Excellent PCB design is extremely helpful for subsequent PCB Assembly, while imperfect design will affect the assembly process and even the quality of products. So Which factors in

Why does open-circuit test give core loss/short-circuit test give copper loss?

2019-06-26

Iron core losses: The magnetic flux in the transformer is flowing on the iron core, and the iron core has magnetoresistance to the magnetic flux, which will generate heat so that this is why open-circuit test gives iron core losses; Copper losses: Coil

Why are vias needed in electronic circuits?

2019-06-26

Honestly, it mainly refers to the function of vias. As you probably know, vias are mainly used to connect lines of each layer. That’s to say, after metallizing treatment, the circuit boards on both sides of vias are connected together.

First - Previous -16 171819 20 21 22 23 24 25 - Next - End

Home About Us Services Quality Pb-Free News Contact Us

Copyright ® 2017,Shenzhen Grande Electronic Co., Ltd. All Rights Reserved. English 中文站 Sitemap